This article covers the SPF and DKIM authentication processes for Mailtarget and how they are managed in Valimail. While only one of the two authentication methods is required for an email to pass DMARC, our recommendation is to configure both whenever possible.

To setup DKIM for your Mailtarget emails, please add the following DKIM key record:

Record type: CNAME

Name: mt1._domainkey.example.com (replace example.com with your domain)

Record/Value: dkim.mailtarget.co

Domain status will be updated automatically no later than 2x24 hours, from you adding the settings. If you see a check mark on the list of countries attached, it means your domain status has been updated.

NOTE: If you manage you domain in Valimail, you will need to add the CNAME DKIM key on your domain's configuration page in the Valimail platform.

You can also find the instructions on how to set up DKIM and SPF for Mailtarget, here.

You can find more detailed information on how to add a DKIM key in Valimail, here:

Once you establish that Mailtarget is an authorized sender for your domain, you will need to add the service in your Enabled Senders.

You will find more detailed information on how to add a service for your domain in Valimail, here:

Note: We encourage you to use the comment section for any useful information about your sending service, such as the name of the service owner, change request ticket numbers, etc.