How to set up DMARC for in Valimail

Updated over a week ago

This article covers the SPF and DKIM authentication processes for and how they are managed in Valimail. While only one of the two authentication methods is required for an email to pass DMARC, our recommendation is to configure both whenever possible.

Configuring DKIM authentication for your emails

Once logged in to Brief Your Market, navigate to 'Verified Domains' from the Admin Tab:


If you have already added a domain, that will be displayed, along with its verification status:


To add a new domain to send from, click the Add Domain button, enter the domain you want to send from, and click verify:


If SPF, DKIM and DMARC are already set up, the domain will verify, but if not, you can enter the email address of your domain administrator, and the setup instructions will be sent to them:


The instructions are specific to your domain, but will look like this:


You can also find the instructions on how to set up DKIM and SPF for, here.

Add a DKIM key in Valimail

You can find more detailed information on how to add a DKIM key in Valimail, here:

Configuring SPF authentication for your emails

Once you establish that is an authorized sender for your domain, you will need to add the service in your Enabled Senders.

You will find more detailed information on how to add a service for your domain in Valimail, here:

Note: We encourage you to use the comment section for any useful information about your sending service, such as the name of the service owner, change request ticket numbers, etc.

Did this answer your question?