Bullhorn

How to set up DMARC for Bullhorn in Valimail

Updated over a week ago
SPF(supported)
DKIM(recommended)

This article covers the SPF and DKIM authentication processes for Bullhorn and how they are managed in Valimail. While only one of the two authentication methods is required for an email to pass DMARC, our recommendation is to configure both whenever possible.

Configuring DKIM authentication for your Bullhorn emails

Create a CNAME record

1. To create a CNAME record, log in to your DNS Hosting Provider and locate the CNAME section in the admin tool.

Each hosting provider has a different interface, but this is typically found under DNS. Example: Click Manage > Click DNS > Add CNAME record.

2. Format the CNAME record as follows, replacing mydomainname with your domain name:

Host: bh._domainkey.mydomainname.com

Points to: bh._domainkey.bullhornmail.com

Important: If you manage DKIM in Valimail, you will need to add the above CNAME DKIM key ion your domain's configuration page in Valimail Enforce.

a screenshot of a computer

3. Contact Bullhorn Support and let us know you are ready to enable DKIM on mass mails to be DMARC compliant and we’ll complete the process on our end.

You can also find the instructions on how to set up DKIM and SPF for Bullhorn, here.

Add a Bullhorn DKIM key in Valimail

You can find more detailed information on how to add a DKIM key in Valimail, here:

Configuring SPF authentication for your Bullhorn emails

Once you establish that Bullhorn is an authorized sender for your domain, you will need to add the service in your Enabled Senders.

You will find more detailed information on how to add a service for your domain in Valimail, here:

Note: We encourage you to use the comment section for any useful information about your sending service, such as the name of the service owner, change request ticket numbers, etc.

Did this answer your question?