Marketo requires special configuration actions outside of Authenticate. Please follow these steps to complete the configuration for Marketo, and then return to your automation-guided task list in Authenticate.



1. In Authenticate, make sure you have added Marketo as an Approved Sender for the domain you are configuring it for.


Note: If Marketo has not been approved, please do so now by following these steps:


a. From the Senders section, click on + ADD SENDER FOR [your domain]

b. Choose Marketo from the Service Name drop-down, and click ADD.






2. Next step is to enable DKIM for your domain in Marketo. You can accomplish this by following the instructions below.


Enable DKIM on your domain in Marketo


1. Open your Marketo account as an administrator


2. Go to the Admin section.

 


3. Click Email, then the DKIM tab, and finally Add Domain.


4. Enter the domain you will be using in Marketo emails as the From Address and click Add.



5. Copy the Host Record and TXT Value and add the DKIM key in Authenticate.



6. Select ADD DKIM KEY in the Authentication configuration page for the Marketo configuration.



7. Enter the values for your DKIM key as provided by Marteko and then click ADD


 

8 Once the DKIM key is added in Valimail Enforce, come back to Marketo, select your domain, and click Check DNS.



9. Once the DKIM key is validated, you will be ready to send authentication emails on behalf of your domain, using Marketo.


Note: The Marketo DNS check may not like the Authenticate SPF Macro and display a warning.  While Marketo will send in alignment, you may need to contact Marketo Support to have them override the SPF validation script in their UI. The SPF response will  work correctly and you can verify this by following the instructions found in this article: Valimail SPF Records