SpamTitan

How to set up DMARC for SpamTitan in Valimail

Updated over a week ago
SPF(supported)
DKIM(recommended)

This article covers the SPF and DKIM authentication processes for SpamTitan and how they are managed in Valimail. While only one of the two authentication methods is required for an email to pass DMARC, our recommendation is to configure both whenever possible.

Configuring DKIM authentication for your SpamTitan emails

To setup DKIM for your SpamTitan emails, please enable DKIM in SpamTitan by following these steps:
โ€‹System Setup -> Mail Relay -> DKIM.

You can also find the instructions on how to set up DKIM and SPF for SpamTitan, here.

Note: You need to be logged in to your SpamTitan's account, in order to access the above link.

Add a SpamTitan DKIM key in Valimail

You can find more detailed information on how to add a DKIM key in Valimail, here:

Configuring SPF authentication for your SpamTitan emails

Once you establish that SpamTitan is an authorized sender for your domain, you will need to add the service in your Enabled Senders.

You will find more detailed information on how to add a service for your domain in Valimail, here:

Note: We encourage you to use the comment section for any useful information about your sending service, such as the name of the service owner, change request ticket numbers, etc.

Did this answer your question?