BuildingLink

How to set up DMARC for BuildingLink in Valimail

Updated over a week ago
SPF(supported)
DKIM(not supported)

This article covers the SPF and DKIM authentication processes for BuildingLink and how they are managed in Valimail. While only one of the two authentication methods is required for an email to pass DMARC, our recommendation is to configure both whenever possible.

Configuring DKIM authentication for your BuildingLink emails

BuildingLink is not known to support DKIM at present time, but that can change anytime.

For more information on this, please contact their support directly at [email protected] or (877) 501-7117.

You can also find more information on SPF authentication for BuildingLink, here.

Add a BuildingLink DKIM key in Valimail

You can find more detailed information on how to add a DKIM key in Valimail, here:

Configuring SPF authentication for your BuildingLink emails

Once you establish that BuildingLink is an authorized sender for your domain, you will need to add the service in your Enabled Senders.

You will find more detailed information on how to add a service for your domain in Valimail, here:

Note: We encourage you to use the comment section for any useful information about your sending service, such as the name of the service owner, change request ticket numbers, etc.

Did this answer your question?